FPV

TBS Discovery Pro with H3-3D

June 25, 2018
321
Views

The TBS Discovery pro was a great frame, with a built in 2 axis gimbal, and the gimbal controller built into the top plate and a power distribution board as the lower plate, this made for an extremely clean and neat build. While the 2 axis gimbal did not provide enough stability on the YAW axis, I custom printed and designed a 3dprinted mount for the DJI H3-3D gimbal equipped with a Lightbridge Full HD video downlink.

 

  • DJI Naza M v2
  • DJI Lightbridge
  • DJI H3-3D Gimbal
  • ImmersionRC UHF TX/RX
  • Spektrum DX9 with ImmersionRC

Leave a Reply

Your email address will not be published. Required fields are marked *